 |
JR456
|
|
JR456
|
Retrofits Allis-Chalmers SJ4, 5, 6, and IJ-2 Controls
| Ready to install | Not necessary to return your old board | 5 minute installation and calibration |
What's so special about our board?
You can use it on Allis-Chalmers SJ4, 5, 6, IJ-2,
and 2A
Or on Load Tap Changers just by flipping a switch
This switch
enables or disables the Seal In circuit
Selector Switch
In the on position, we use an optical coupler to sense the motor current and seal in the circuit until a tap change is made, then it samples the voltage with no motor load and, if satisfied stops. If not yet in band will sample voltage for 1.5 seconds and take another step and continue sampling the input voltage between steps for 1.5 seconds until it is in band.
In the off position, the Seal In Circuit is disabled
To get more information or place an order phone, fax or Email
| Phone (740) 962-5171 | Fax (740) 962-5807 | Toll Free (800) 325-0387 |
